The project was a modification of a JDM PIC programmer and has to be connected through the serial communication port of the computer without the use of any external power supply. The project was a ...

ZEPPP : Zero External Parts PIC Programmer ZEPPP is a PIC programmer that requires only an Arduino-compatible board and a small command-line PC utility (CLI) to read, write, erase and verify several ...

PICはマイコンなのでプログラムを作るには開発環境が必要だ。ところが、多くの技術者に開発してもらえないとPICそのものがたくさん売れない、という事情があって、「最低限の開発環境」なら開発元謹製のものが「タダ」で手に入る。 ここでいう「最低限 ...

This simple programmer will accept any device that’s supported by software (eg, IC-Prog 1.05 by Bonny Gijzen at www.ic-prog.com). The circuit is based in part on the ISP header described in the ...

[Kirill] wrote in to share his Arduino-based PIC programmer. It is capable of writing to the 18F family of chips, including 18F2XXX and 18F4XXX. We think that’s pretty exciting because this line of ...

I’m sick today, but finally getting some entries up. [Albert] designed this board which can be either a low voltage PIC programmer or, if you lack a programmer to get the initial flash data on the PIC ...

(symbol "pic_programmer_schlib:CP" (pin_numbers hide) (pin_names (offset 0.254)) (in_bom yes) (on_board yes) ...